I’m having trouble getting a continuous flow of water. It just peters out after a couple of seconds and spits and sputters. What should I do?
The tube inside the bottle has either detached from the fitting during transportation to you or there is a crack/split in the tube.
1. Open the screw cap connector on the bottle and check if the tube inside is still connected. Reconnect if it has come apart.
2. Check for any cracks/splits in the tube by removing it from the fitting and visually check the tube (particularity the end pieces).
3. If you have found a split/crack try turning the tube upside down, reattach to the connector and re-screw the connector firmly to the bottle (see pics below for guidance).
4. Try your Beach Shower again to see if the water is flowing in a continuous manner.
Contact us for a free replacement tube if still within the Warranty period or purchase a replacement tube if outside of the Warranty.
Related Articles
I’m having trouble getting a continuous flow of water. It just peters out after a couple of seconds and spits and sputters. What should I do?
The tube inside the bottle has either detached from the fitting during transportation to you or there is a crack/split in the tube. 1. Open the screw cap connector on the bottle and check if the tube inside is still connected. Reconnect if it has ...The trigger on the shower head has popped off and I can’t control the flow of water. What should I do?
It sounds like the shower head clips may be broken. If you still have the trigger part (the part that moves up and down to control water flow) you will just need to grab some replacement shower head clips to get you back up and running. If you have ...How long does the water stay warm?
This varies a lot and depends on your surroundings, the temperature of the water you filled it with and the climate, so it’s very difficult to predict. With an average day temp of 66°F/18°C, a Beach Shower will keep the water warm for a couple of ...How can I warm the water?
Our Beach Showers operate on a super simple system - just fill with warm water (<50°C/122°F) for safety reasons and to protect the unit itself) and the 4mm (0.15inch) neoprene cover will then keep it warm for a few hours so you can enjoy a nice and ...I can’t seem to fill it up with water properly and when I remove the handle, only the thin cylinder in the centre fills. It seems to be very time consuming to fill it and i'm not sure how it will hold all the water. What's going on?
It sounds like you may be trying to fill up the actual pump handle itself. 1. Please try to remove as much water as you can by just turn it upside down and giving it a shake 2. Replace the cylinder into the fitting and tighten up the handle again ...